A CrossFit competitor sprinting between loaded barbells during a timed mixed-modal workout

72 Deadlifts and 2.4K of Running: The WOD That Exposes Your Pacing

UPLIFT IRON CLUB

72 Deadlifts, 2.4K of Running: What This WOD Really Demands

A CrossFit competitor pulling a loaded barbell during a competition

A workout can look straightforward on a whiteboard and become an entirely different animal once the clock starts. This October 29 session pairs repeated barbell deadlifts with short runs, then asks athletes to do it again before their breathing and posterior chain have fully settled. The challenge is not a maximal deadlift or a fast standalone 400-meter time. It is keeping two familiar movements efficient while the fatigue from each spills into the next.

The prescribed format is three sets. Each set begins with a 200-meter run and 12 deadlifts, followed by another 200-meter run, a one-minute rest, six deadlifts, a 400-meter run, six more deadlifts and another minute of rest. The standard barbell prescription is 225 pounds for men and 155 pounds for women, with a 28-minute cap and an intended finishing window of roughly 21–26 minutes. Those are programming reference loads, not a challenge to prove that everyone should use them.

Do the arithmetic before loading the bar. Each set contains 24 deadlifts and 800 meters of running. Across three sets that is 72 deadlifts and 2,400 meters, with short prescribed pauses inside the structure. The deadlift repetitions arrive in different-sized chunks, and the longest run comes after the first 18 pulls of each set. That sequencing matters. You are repeatedly asking tired hip extensors and trunk stabilizers to produce clean running strides, then asking them to brace against a bar again.

This is a muscular-endurance and pacing test built on a strength movement, not a conventional heavy-strength session. The best result is not necessarily the athlete who rips the first 12 deadlifts fastest. It is the athlete whose third set still looks like an athletic performance rather than an improvised argument with gravity. The one-minute pauses should be used deliberately: slow the breathing, check the grip, walk to the next starting point and decide how the next barbell set will be broken up.

There is also a simple training lesson for lifters who rarely run. Being strong at one hard pull does not automatically mean you can preserve a good hinge for 72 repetitions while your heart rate is elevated. Likewise, being a good runner does not guarantee that your trunk and grip will tolerate repeated loaded hinges. The workout makes those gaps visible without requiring any exotic equipment.

Gym apparel product
CrossFit Club Tee
SHOP NOW

The Deadlift Setup That Still Works on Rep 60

A male athlete setting up a barbell deadlift in a functional fitness gym

When deadlifts appear inside a timed workout, speed should come from a repeatable setup, not from skipping the setup. Start with the bar over the middle of the foot, feet roughly hip-width apart, hands just outside the legs and the shoulders slightly ahead of the bar. Take a breath, create tension around the trunk, engage the lats so the bar stays close, and push the floor away. The hips and shoulders should rise together until the bar clears the knees.

The most expensive mistake is allowing the bar to drift forward as fatigue accumulates. A small forward displacement makes the lift feel substantially harder because the load is farther from the body's balance point. The next mistake is treating the descent as a free fall followed by a frantic bounce. Lower the bar by sending the hips back first; once the bar passes the knees, bend the knees to return it to the floor. Rebuild your brace before the next pull, particularly when the reps become visibly slower.

For this format, think in clusters of clean repetitions. A competent athlete might perform the opening 12 as 7+5 or 6+6, taking a few breaths while standing upright between clusters. A stronger, well-conditioned athlete may go unbroken without losing position. Both strategies are valid if the bar stays close, the trunk remains controlled and the subsequent run is not destroyed. Unbroken is a pacing choice, not a moral achievement.

Grip matters because there are 72 opportunities for a slipping bar to interrupt the workout. Double-overhand is simple and develops grip capacity, but a secure alternate grip or permitted straps may be appropriate depending on the setting and coaching standards. Avoid twisting the torso to compensate for an asymmetrical grip. If a hand starts to open unexpectedly, put the bar down and reset rather than attempting a desperate save with a rounded back.

Warm up the actual pattern, not just the cardiovascular system. Begin with a few minutes of easy movement, then use light Romanian deadlifts, deliberate empty-bar deadlifts and a couple of small increases in load. Add one short run before the work begins so the first transition is not a surprise. A useful rehearsal is five controlled deadlifts, 100 meters of easy running and three more deadlifts. If your technique falls apart in rehearsal, the prescribed load is too ambitious for today's conditioning session.

Finally, distinguish effort from pain. General fatigue in the glutes, hamstrings and back musculature is expected. Sharp pain, radiating symptoms, dizziness or an inability to maintain basic positions are reasons to stop and reassess, not cues to prove toughness. The barbell should challenge your capacity; it should not force you to gamble with it.

Gym apparel product
Hybrid Athlete T
SHOP NOW

Why Running Feels Different After Heavy Hinges

CrossFit athletes running together outside their training gym

Running between deadlift sets is not a neutral recovery interval. The glutes and hamstrings that extend the hips under a bar also contribute to propulsion and limb control during running. The trunk has to organize each foot strike while the respiratory system is already busy recovering from the preceding pulls. That is why the first few strides after a heavy set can feel stiff, short and oddly expensive even when the running distance looks harmless.

Laboratory work has shown that a resistance-training session can temporarily worsen running economy, meaning more oxygen is needed to maintain the same submaximal pace. That does not prove the exact effect of this particular workout, and a short interval is not identical to a treadmill test. It does, however, support a practical observation: strength fatigue can change how much a given running speed costs. A pace that feels easy when fresh may become unsustainable when repeated between loaded hinges.

Use the first 30–50 meters after the barbell to find your stride. Keep the shoulders relaxed, avoid exaggerated bounding and let the legs settle into a quick, comfortable cadence. Accelerating aggressively straight from the final deadlift often creates a spike in breathing that you will pay for when you return to the bar. The goal is to arrive ready to lift again, not to win a 200-meter race that nobody is scoring separately.

The 400-meter run is the most revealing section. It arrives after a six-rep deadlift segment, so it rewards a controlled start and an even middle rather than an opening sprint. If you cannot speak a short phrase by the time you reach the midpoint, ask whether the effort is sustainable for the rest of the session. Stronger runners may hold a brisk pace; others will be better served by a controlled jog. The right speed is the one that protects the next lift.

A useful cue is run tall without overstriding. Think of feet landing relatively close beneath the body, arms moving smoothly and breathing rhythmically. If the back feels locked up, shorten the stride for a few seconds instead of leaning dramatically forward. Walking for 10–20 seconds can be a smart tactical decision if it allows the next set of deadlifts to remain safe and continuous.

There is no need to turn this into a debate about whether cardio kills gains. The acute fatigue from running after deadlifts is real, but it is not evidence that combining strength and endurance training is inherently bad. The relevant variables are total training load, exercise order, recovery and your primary goal. A dedicated powerlifting day and a mixed-modal conditioning day can coexist if you stop treating both as opportunities to set a deadlift record.

Gym apparel product
Hybrid Athlete Crew
SHOP NOW

Pace Three Sets Instead of Winning the First One

A CrossFit athlete running between stations on a competition floor

The smartest pacing plan begins with a target for the whole workout. With a 21–26 minute intended range and a 28-minute cap, the clock is tight enough to discourage wandering but generous enough that a controlled athlete should not need to sprint every segment. The programmed one-minute breaks are already part of the time budget. The question is how much additional time you can spend setting up, breathing and splitting repetitions without falling behind.

Before starting, establish a realistic running pace and a deadlift rep scheme. If you normally run 400 meters in two minutes during hard intervals, do not assume you can reproduce that pace six times around repeated deadlifts. Instead, test one 200-meter run and a small deadlift cluster at the intended load. Notice whether you can recover your breathing within the following minute. A workout pace that only works in the first set is not a plan; it is an opening bid.

For a concrete example, an athlete might run the first 200 meters at a controlled effort, break 12 deadlifts into 6+6 with a brief standing reset, jog the next 200 meters, use the prescribed rest to slow breathing, complete six crisp pulls, run the 400 meters evenly and finish the last six pulls without racing the bar to the floor. That pattern is easy to remember. It also makes it obvious where time is being lost if the third set drifts.

Track set-to-set consistency rather than obsessing over a single split. If the first set takes six minutes and the next two take nine each, the early pace was probably too aggressive. A steadier sequence can produce a better final time even if the opening minutes look less impressive. The exact split targets depend on your running ability, barbell load and transition layout; there is no universal magic pace.

Use the rest windows actively but calmly. Stand upright, take several deliberate breaths, shake out the hands, and decide whether the next deadlift set should be unbroken or split. Avoid sitting or lying down unless you genuinely need to stop. A quick drink is fine, but spending half the break fumbling with equipment is wasted recovery. Keep the bar and running route arranged so that transitions do not become an obstacle course.

Technique is the final pacing indicator. If your bar speed collapses, your knees stop tracking predictably, or the bar repeatedly drifts away from the shins, slow down or reduce the load. Research on resistance exercise and high-intensity functional workouts shows substantial mechanical fatigue can accumulate under time pressure. That finding is a reason to monitor movement quality, not a license to assume that every ugly rep is harmless because the workout is timed.

Gym apparel product
Hybrid Athlete Tank
SHOP NOW

Scale the Workout Without Losing the Point

A CrossFit athlete lifting a loaded barbell during a scaled conditioning session

The intended stimulus is repeated moderate-to-heavy hip hinging interrupted by running, with enough intensity to challenge breathing and muscular endurance. It is not tied to a sacred number on the barbell. The published options include a lighter intermediate barbell prescription, a beginner version with shorter runs and fewer repetitions, and a travel option using two dumbbells for Romanian deadlifts. Those choices are useful because they preserve the pattern while changing the cost.

For an athlete who has not yet built a consistent deadlift technique, the best scaling decision is usually to reduce load first. Choose a weight you can lift for six crisp reps even when breathing hard. If the first 12 already require a maximal-effort grind, you have selected a strength-test weight for an endurance workout. The goal is a repeatable hinge, not an accidental one-rep-max session disguised as cardio.

If the running is the limiter, reduce the 200-meter legs to 150 meters and the 400-meter leg to 300 meters, as in the beginner framework. That still creates meaningful transitions and keeps the workout moving. For someone returning from a break, a brisk walk or an easy bike interval may preserve the cardiovascular challenge without the impact of repeated runs. Treat these as deliberate substitutions, and record them so future comparisons are fair.

The travel version is particularly practical. Two dumbbells can be used for Romanian deadlifts with a controlled descent and a hip-dominant movement. Because the weights do not return to the floor on every rep, this is not a mechanically identical substitute for a conventional barbell deadlift. It emphasizes the hinge and posterior chain but changes the range of motion and how the load is managed. Use it as a comparable conditioning challenge, not a one-to-one strength benchmark.

A simple scaling ladder works well: first protect technique, then preserve the repeated transitions, then increase intensity. Start with a load and distance that allow all three sets to look similar. In a later session, increase one variable at a time: slightly heavier pulls, slightly faster running, fewer unplanned pauses or a more demanding version of the exercise. Changing every variable at once makes it difficult to know what improved.

People with acute back symptoms, unresolved injuries or significant exercise limitations should use individualized guidance rather than forcing the standard version. There is nothing heroic about turning a conditioning session into a pain-management experiment. A lighter, technically consistent workout that you can recover from is more valuable than a heavier one that disrupts the next week of training.

Recovery, Progression and the Next Three Weeks

An athlete seated on the gym floor stretching her hamstrings after training

A mixed running-and-deadlift workout creates two kinds of fatigue at once. Your breathing may recover relatively quickly, while the glutes, hamstrings, spinal erectors and grip can remain tired much longer. Do not assume that feeling normal an hour later means the posterior chain is ready for another demanding hinge session. The next day's training should reflect how you actually move, not only what the calendar says.

After finishing, walk for a few minutes to bring the heart rate down and drink according to thirst and conditions. Light mobility or easy stretching can feel good, but it is not a substitute for sleep, food and sensible programming. A normal meal with protein and carbohydrates supports recovery; there is no need to invent a complicated supplement ritual. If you are unusually sore, choose easy movement rather than another maximal deadlift workout.

For lifters who want to improve this specific combination, a three-week mini-block can develop the component skills without repeating the full 72-rep test constantly. Week one: practice the deadlift pattern with four sets of six controlled reps at a comfortable load, then complete four relaxed 200-meter runs with generous rest. Week two: alternate five deadlifts and 200 meters of running for four rounds, keeping every round technically consistent. Week three: perform two sets of the original workout at a sensible load, compare splits, and stop before form deteriorates.

That mini-block is an example, not a mandatory progression for every athlete. Place the harder mixed session away from your heaviest lower-body day, especially if your training also includes squats, Romanian deadlifts or intense intervals. If muscle growth is your main priority, keep high-quality resistance training as the foundation and use a scaled version of this WOD for conditioning. If hybrid performance is the priority, make the running and transitions progressively more specific.

Record four useful numbers: total time, barbell load, how you split the deadlift sets and the slowest run or round. Add a short note about movement quality. Those details reveal more than the finishing time alone. A faster result achieved by reducing the load is not directly comparable with the original prescription; a slower result with markedly cleaner lifts can still represent useful progress.

Most importantly, judge the session by whether it builds capacity you can repeat. A successful workout leaves you challenged, perhaps humbled, but still able to train productively afterward. Seventy-two deadlifts and 2.4 kilometers of running are enough work to expose weak pacing and technique. They are not a requirement to abandon either one. The strongest athletes know when to push and when to keep the next rep clean.

Functional Fitness Shirts and Workout Gear collection
Functional Fitness Shirts & Workout Gear

Functional-fitness shirts, tanks and workout gear for athletes who train strength, conditioning and everything in between.

EXPLORE COLLECTION

More CrossFit stories

Back to blog

Leave a comment